FREE
& CANADA!
**We accept US funds only -
Thank you!

Credit Cards

Volusion SSL Seal
facebook
You are here: Home > In Feed
Sort By:
Page of 2
WM series Infeed Drive Axle Boot
WM series Infeed Drive Axle Boot
$10.00

This rubber boot protects the U-joint on the in-feed drive axle for the WM-8M
(WC-8N) A38 V-Belt (Infeed Drive Belt)
(WC-8N) A38 V-Belt (Infeed Drive Belt)
$14.00

A-38 V-Belt for in feed drive roller reduction worm gear.  Fits (WC-6N) (WC-8N).
(WM Series) Infeed Roller Tension Suspension Spring
(WM Series) Infeed Roller Tension Suspension Spring
$15.00

Heavy duty tension spring for WM series chippers. These springs apply up to 170 lbs of down pressure on the limbs.
(WM-Series) Directional Control Valve (lever rod & handle only)
(WM-Series) Directional Control Valve (lever rod & handle only)
$15.00

Handle for WM-8H control valve. Does not include cap and actuator.
(WC-8N) Infeed Roller Tension Spring
(WC-8N) Infeed Roller Tension Spring
$15.00

The tension spring applies downward pressure on the in feed roller. The machine has 2 of these - sold separately.
Fits (WC-6N) (WC-8N)
(WM-8H) BX43 Hydraulic Pump Drive Belt
(WM-8H) BX43 Hydraulic Pump Drive Belt
$19.50

Drive belt for hydraulic pump.
Fits (WM-8H)
(WM-8H) Hydraulic Control Lever Cap (2-hole)
(WM-8H) Hydraulic Control Lever Cap (2-hole)
$25.00

Hydraulic control lever cap (2015 and newer)
(WM-8M)  Feed Roller Disengage Cable Assembly Includes part (WM8M-7-11,12,13,14,15,29)
(WM-8M) Feed Roller Disengage Cable Assembly Includes part (WM8M-7-11,12,13,14,15,29)
$35.00

This cable connects the feed roller clutch to the in-feed bin safety bar on machines sold prior to May 2012
Infeed Roller Bearing (F204-20mm 2-hole flange)
Infeed Roller Bearing (F204-20mm 2-hole flange)
$38.00

Infeed Roller Shaft Bearings. 2 Hole Flange Bearing with 2 Set Screws. 20mm
Fits (WC-6N) (WC-8N) (WM-8M) (WM-8H) (TM-86H)
(WM-8H) Hydraulic Pump Thrust Adapter With Pulley and Gasket
(WM-8H) Hydraulic Pump Thrust Adapter With Pulley and Gasket
$65.00

Hydraulic pump thrust adapter with pulley and gasket. This assembly mounts to the frame of the chipper and holds the hydraulic pump in place to absorbs the lateral pull of the pump drive belt. There are two permanently sealed bearings that require no lubrication.